aftermarket door quality

[blazerboy72]

He said he sold his last pair a week ago but he will find me another set. If I hear back from him I can send his number to yall.

[tphsmith]

my after market good marks, I am very upset with them, in pics above seeing that seam sealer, well after my door was painted and put all together the front side of the door where the seam is has separated real bad, so bad I cant open the door with out damaging the edge of my fender now, very up set with after market doors

[Kayotic]

I guess the point is - Good quality is hard to find. Like going to a lumber store and sifting through stacks of lumber to get what you want. If you are close to a supplier, stop in and see what they have.

I was hoping for better results, would be easier to thumb through a catalog and order shiny new sheet metal. Could end up being a hassel in the long run.

Original metal it is - where posible.

[Hart_Rod]

Originally Posted by Kayotic

I guess the point is - Good quality is hard to find. Like going to a lumber store and sifting through stacks of lumber to get what you want. If you are close to a supplier, stop in and see what they have.

I was hoping for better results, would be easier to thumb through a catalog and order shiny new sheet metal. Could end up being a hassel in the long run.

Original metal it is - where posible.

It's out there, you just gotta keep looking. Boardmember UNCLE in Atlanta usually has some pretty good stuff......

[Kayotic]

Originally Posted by Hart_Rod

It's out there, you just gotta keep looking. Boardmember UNCLE in Atlanta usually has some pretty good stuff......

Thanks for reminding me. I have heard of the name from a lot of fellow enthusiasts. When I was hunting Ebay and Craigslist, I would contact people and they would say the same thing.

As a matter of fact, I am here(on the board) because of a referral from a guy in Florida who had a frame I was intrested in. He said "Look for UNCLE in Atlanta".

Great call - thanks again. I hope he takes CASH....

[PHAT TONY]

I don't know what's available states-side, but up here(in the cold cold north), I've had very good luck with a company called Gordon(taiwanese like everything else). I think they're a tad thicker, not OEM grade-but, and they're certified for fit and finish. Not a bolt on and scuff 'er down deal but very reasonable for what's out there.