03-16-2011, 12:02 PM | #26 |
Windy Corner of a Dirty Street
Join Date: Jun 2003
Location: Pueblo West, Colorado
Posts: 2,926
|
Re: 8.1
The 8.1L is dimensionally the same as any other big block but the cast aluminum oil pan is much bigger than any other big block and WILL definitely interfere with the stock engine cross-member. I used an ORD high clearance oil pan and spaced up the engine mounts with a piece of plate steel.
ORD HD cross-member Even with the ORD HD cross-member I felt the need to space the engine mounts upward a tad more to give just a bit more wiggle room. After spacing. The picture view gives the illusion it is almost touching but in reality you can stick your finger between the oil pan and cross-member. I have been running it like this for two years and a lot of off-roading with no issues or signs of rubbing.
__________________
Current vehicle collection: 1978 Chevrolet K10, 8.1L, NV4500, NP205 1989 Chevrolet Suburban, 8.1L, NV4500, NP241 1993 Chevrolet C1500 Sportside, TBI 7.4L, 4L60E 2001 Chevrolet K2500HD, Ext Cab, SWB, 8.1L, ZF 6 speed 2014 Chevrolet Impala LTZ 3.6L Vortec 8.1L because life is too short to tolerate underpowered vehicles
|
03-16-2011, 12:12 PM | #27 |
Registered User
Join Date: Aug 2010
Location: Gonzales,La
Posts: 65
|
Re: 8.1
I stand corrected.
Posted via Mobile Device |
03-16-2011, 10:09 PM | #28 |
Registered User
Join Date: Dec 2010
Location: Dallas, TX
Posts: 160
|
Re: 8.1
Excellent, thank you Larry. I had a few hunches about what needed to be done to get one in a K5 but an exact outline of how to do it is GOLD to me. That will make my life much easier when I tear the TBI engine out and drop the 8.1 in.
__________________
2010 Basalt Black Porsche Cayenne GTS - Daily driver 1991 2500 Suburban, Black - 454/80E tow monster, soon to go under the knife... Again. 1979 16' Action Marine/"Johnny Cash" Merc Bridgeport Champ Motor - Metalflake Maniac |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|