AZ Cab & frame cuts 67 2 wheel drive

[smmf]

How much for the front frame "horns"

[67ratswb]

hi tom, waiting on info for rear side to side cab mount when you get a chance. thanks. mike

[t korinek]

67rat Rear cab Mount is ok, left floor support is ok, right side is rusted out $50+ shipping

Smmf $35 ea on frame horns + shipping

Kcmoto I have that on another cab in good shape, $50 for as much as need + shipping

Michael $45 ea + shipping on those
Hope I got everybody

Thanks
Tom

[t korinek]

Pics for d passmore

[67 Blue Truck]

Did you get my pictures through email?

Thanks,
Joel

[kxmotox247]

Sounds good. Does the top half of that section physically match the bottom? If it's the same shape/contour it may be a lot easier to cut out since there is no floor or floor brackets in the way.
I'll measure tomorrow morning for how much I need.

[t korinek]

Kxmoto I believe it does , here’s a pic of what I have on that particular cab right now, not sure if there’s enough on that cab or not? If not I have another one I can hack up��

Blue truck I have those pieces $45 ea + shipping

[kxmotox247]

I don't see much left on that one. I guess the center rib is still there. Did you say you have another cab with that area?

[kxmotox247]

I'm wondering if the opposite end can be used to patch in the bottom. I think the shape is the same. So maybe off another cab?

[projectking]

Originally Posted by kxmotox247

I'm wondering if the opposite end can be used to patch in the bottom. I think the shape is the same. So maybe off another cab?

I believe it does minus the bend at the bottom

[michael bustamante]

can I get pics of those floor patches?

[t korinek]

The other cab back

Michael floor pans are rusty

[kxmotox247]

Originally Posted by t korinek

The other cab back

So how do we work out getting a few pieces from that cab back? I need to be able to repair 5 of the vertical strips. I'm thinking around 12-16" tall and then I can cut to fit once I have them in my hands? Maybe three sections out of the top or the bottom if they are the same. Two sections is fine also. Whatever ships the easiest.

[davreich]

Hi,
How much for the front sway bar and mounts? Also, are trailing arms in great shape? If so how much. Shipping to 37807 Thanks, Dave

[t korinek]

$75+ shipping for the sway bar & brackets + shipping.
These trailing arms are no good, I probably do have a good set $150 + shipping

[D.PASSMORE]

Ok Tom, hit you tomorrow morning with payment. I'll include shipping address in the notes in payment transaction. Thanks D/

[davreich]

Hi Tom,
I'll take the front sway bar and mounts for now. I will PM my email address. PayPal?? Thanks

[davreich]

Hi,
Did you get my PM?

[SVFK5]

I'll take the entire driver's side frame rail, if it isn't cracked or damaged? Cost with shipping to 49544?

[SVFK5]

Sorry I didn't realize this was a C10, looking for Blazer/Jimmy. Please disregard

[KMC3420]

Any luck in finding a passenger side front fender cup? Thanks.

[t korinek]

Here’s the pics

[KMC3420]

I will take it. PM me some payment info and total, thanks.

[kiwikid]

i need some roof cuts with good drip rails would you have ? thanks

[Graham57a]

I need a floor board patch under the gas pedal. Any photos of that area?