CA Parting out '85 Sierra Classic 1500 4X4

[skeet85silverado]

Do u have the ac ducts that are under the dash. Also the one plastic piece that goes from diverside ac vent to under the steering wheel to the ac box.

[Jerry Jones]

Originally Posted by 5bassman

Sounds fair. What condition are the left heat vent and adapter for it behind the dash and the center heater vent?
Posted via Mobile Device

Drivers vent seems ok, center vent is a little sloppy with the up and down function... it could probably be remedied easy enough. Are you talking about the plastic duct that goes from the left vent to the ac box?

[5bassman]

Originally Posted by Jerry Jones

Drivers vent seems ok, center vent is a little sloppy with the up and down function... it could probably be remedied easy enough. Are you talking about the plastic duct that goes from the left vent to the ac box?

I need the Small box that hold the vent at the drivers left knee. Might as well leave the vent in it too.

http://www.classicparts.com/1973-91-...info/68%2D621/
Also could use several of the chrome colored vents.
Posted via Mobile Device

[Jerry Jones]

Originally Posted by 5bassman

I need the Small box that hold the vent at the drivers left knee. Might as well leave the vent in it too.

http://www.classicparts.com/1973-91-...info/68%2D621/
Also could use several of the chrome colored vents.
Posted via Mobile Device

Is this everything you are asking for?

[ChaseDale3and8]

How much for the 4 headlight wiring harness if it is still available? It would have to be shipped to 65619. Thanks! ...Joe

[Jerry Jones]

Originally Posted by ChaseDale3and8

How much for the 4 headlight wiring harness if it is still available? It would have to be shipped to 65619. Thanks! ...Joe

How about $60 shipped?

[ChaseDale3and8]

Originally Posted by Jerry Jones

How about $60 shipped?

Do you take PayPal? I want it. Thanks! ...Joe

[Jerry Jones]

Originally Posted by ChaseDale3and8

Do you take PayPal? I want it. Thanks! ...Joe

Yup, PM sent.

[ChaseDale3and8]

Originally Posted by Jerry Jones

Yup, PM sent.

You've got money! Thanks! ...Joe

[Jerry Jones]

Packaged and will ship tomorrow

[ChaseDale3and8]

Originally Posted by Jerry Jones

Packaged and will ship tomorrow

Thanks! I'll let you know when it gets here. ...Joe

[marhil61]

I'm looking for two 15 x 6, 6 lug stock steel wheels that will fit over disk brakes if you come across any. Thanks.

[Jerry Jones]

Originally Posted by marhil61

I'm looking for two 15 x 6, 6 lug stock steel wheels that will fit over disk brakes if you come across any. Thanks.

I do not have stockers, but if I see any I will let you know.

[ChaseDale3and8]

The wiring harness just got here today! Thanks! ...Joe

[Jerry Jones]

Originally Posted by ChaseDale3and8

The wiring harness just got here today! Thanks! ...Joe

Nice harness, right? Enjoy!

[5bassman]

Originally Posted by Jerry Jones

Is this everything you are asking for?

Sorry, been out of the country for the last two weeks. Just need the three a/c vent pieces shown in the middle, not the ac tube or right side tube. I believe someone else was asking about the tube. What shape are the vents in?
Posted via Mobile Device

[5bassman]

Originally Posted by Jerry Jones

Is this everything you are asking for?

Does the tube on the right have the vent in it?
Posted via Mobile Device

[ChaseDale3and8]

Originally Posted by Jerry Jones

Nice harness, right? Enjoy!

I'm pleased with it! I'm also wanting a really good set of cab mount bolts/washers. Mine are shot. Got my radiator support out right now as I'm doing an engine swap. When I unbolted the radiator support to frame bolts the washers underneath completely disintegrated! They were the worst rusted parts that I've seen so far on this truck! I took a look at the other 4 bolts/washers and they aren't in very good shape either. How good are the ones on this truck?

Also looking for a bracket for the A/C. Want the one that bolts to the exhaust manifold. I want to keep my original just in case I want to do a original restoration on it some day, but since my new small block is going to have headers, and I want to keep the A/C compressor intact, I need one that I don't mind cutting on to make it fit around the headers. Let me know what ya got. Thanks! ...Joe

[fanmanj]

A/C coompressor any good?
Posted via Mobile Device

[countryguy]

Does it happen to have a bolt in tranny hump/tunnel?

[Dusty4x4]

Is the driver side floor support any good?

[superwade57]

im looking for the rubber wedge and bolt that holds the battery in place can you help?

[Jerry Jones]

Originally Posted by 5bassman

Sorry, been out of the country for the last two weeks. Just need the three a/c vent pieces shown in the middle, not the ac tube or right side tube. I believe someone else was asking about the tube. What shape are the vents in?
Posted via Mobile Device

the vents look good, but 2 of them have a fin that is broken in the back so all of the fins don't move together.

Originally Posted by 5bassman

Does the tube on the right have the vent in it?
Posted via Mobile Device

It does not have the vent in it, the vent from it is one of the vents mentioned above.

Originally Posted by ChaseDale3and8

I'm pleased with it! I'm also wanting a really good set of cab mount bolts/washers. Mine are shot. Got my radiator support out right now as I'm doing an engine swap. When I unbolted the radiator support to frame bolts the washers underneath completely disintegrated! They were the worst rusted parts that I've seen so far on this truck! I took a look at the other 4 bolts/washers and they aren't in very good shape either. How good are the ones on this truck?

Also looking for a bracket for the A/C. Want the one that bolts to the exhaust manifold. I want to keep my original just in case I want to do a original restoration on it some day, but since my new small block is going to have headers, and I want to keep the A/C compressor intact, I need one that I don't mind cutting on to make it fit around the headers. Let me know what ya got. Thanks! ...Joe

I would think that the bolts would be in good shape, I have not run into any hardware issues with this truck (so far). I can check this out this weekend if not before.

Originally Posted by fanmanj

A/C coompressor any good?
Posted via Mobile Device

A/C was in great working order before I started taking thing apart.

Originally Posted by countryguy

Does it happen to have a bolt in tranny hump/tunnel?

I am not sure I can check this out this weekend if not before.

Originally Posted by Dusty4x4

Is the driver side floor support any good?

I have not been under the truck yet, I will try to check that out this weekend if not before.

Originally Posted by superwade57

im looking for the rubber wedge and bolt that holds the battery in place can you help?

I got a set in nice shape, $8.50 shipped?

[weider1717]

Originally Posted by Jerry Jones

Is this everything you are asking for?

I need the top big tube if you still have it?

[Jerry Jones]

Originally Posted by weider1717

I need the top big tube if you still have it?

I do still have it, how about $30 shipped to Greenville.