WTB: 4 junk rods/pistons

[low 84]

i need a set of 4 rods and pistons. they do not have to be useable in an engine, but i would prefer that they don't have extensive damage. rust and wear is fine. can be any size small block or big block. just need 4 preferable witht eh rods still pressed on.

not looking to pay alot because i'm not looking for parts that can be used in an engine, they are for something else. so if anyone has some junk ones sitting in the garage let me know how much you want for them. thanks

[Russell]

Hey Man!

I've got a couple grimy and rusty 350 pistons with rods still attached sitting in my scrap metal pile, you can have them for 10 US + shipping

[Staceydude]

Try hitting one of the pick and pulls and tell them what you are looking for, some of them will have junk stuff laying all over the place for real cheap.

Regards,

Stace

[bigblock73]

Working on the coffee table bud?

I wish I could help, but i don't have what you are looking for.

[CHEVYJEFF]

Let me know next time your in town I have a set and i know where two other sets are. stock smallblock rods.

[TooMany2count]

must be making a Piston Throw game for car shows????...joe

[low 84]

yep i'm building a coffe table from an ls1 block i got from another member awhile back.

russle, i think shipping from canada to texas might be expensive, i don't know though?


jeff, i was just up in dallas last week, i should have posted this last week i guess, lol. i won't be back up there for awhile but i can send you some money for shipping plus some for your trouble if you dont' mind shipping them. let me know

thanks guys

[CHEVYJEFF]

Let me dig around for some clean ones. you need 4 correct. with or without pistons? If you really want to get fancy I have a set of 8 childs and albert aluminum rods you can have for 150.

[Russell]

Shipping would probally be around 20 bucks cnd or so, not bad at all, just takes 2 - 4 weeks to get there...

Best would probally be local though, but mine are available if you want em

[low 84]

jeff i need 4 rod with pistons. dosen't matter if they are clean or not. i will just sand them and paint them. they are just going to be supports for glass on a coffee table. the childs and alberts would be badass but i'm building this thing on a pretty small budget, lol

[1972C10]

I know i have some old SJ rods and pistons but they are seized I may have some other ones ill check .

[1FaastC10]

mine will probably end up being a Pontiac engine, since i have an extra laying around...

[low 84]

ttt