Question: How bolts are holding the manual tranny to the bell housing? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Ice68 · 04-27-2006, 12:29 AM

Help!

How many bolts are holding the original 1959 Chevy 3100 transmission to the bell housing? We found two upper bolts where you put the guilding bolts at, but we still can't detach the tranny from the bell housing. Any info will be appreciated.
Thanks!

Apache · 04-27-2006, 02:09 PM

Should be 4, two upper and two lower.

Ice68 · 04-27-2006, 03:12 PM

Quote:

Originally Posted by Apache

Should be 4, two upper and two lower.

Thanks for the reply. We are disassembling my '59, and we just need to take the engine and tranny out to take our frame to the sandblasters.
Thanks,
Leroy

dwcsr · 04-27-2006, 07:11 PM

there are two inside the bell that are a pain in the A** to get at. and two on the outer top.

Ice68 · 04-28-2006, 01:44 AM

Quote:

Originally Posted by dwcsr

there are two inside the bell that are a pain in the A** to get at. and two on the outer top.

Thanks for the info. We finally realize that there were two bolt inside the bell housing except that our '59 truck had only one bolt inside. We were puzzled about that bolt when we were able to take the engine off our frame.

We were wondering if it was bolted the right way. Thanks again for the info.

04-27-2006, 12:29 AM	#1
Ice68 Registered User Join Date: Dec 2003 Location: NW New Mexico Posts: 236	Question: How many bolts are holding the manual tranny to the bell housing? Help! How many bolts are holding the original 1959 Chevy 3100 transmission to the bell housing? We found two upper bolts where you put the guilding bolts at, but we still can't detach the tranny from the bell housing. Any info will be appreciated. Thanks! __________________ '68 Chevy Truck C10 LWB 292 engine 3spd Tranny Everything Stock except for shaved bodywork. '72 Chevy Truck Custom Deluxe 2WD LWB 350/350 HEI Tilt PS AC Dual Exhaust Last edited by Ice68; 04-27-2006 at 12:39 AM.

04-27-2006, 02:09 PM	#2
Apache Registered User Join Date: Jun 2004 Location: South Carolina Posts: 419	Re: Question: How bolts are holding the manual tranny to the bell housing? Should be 4, two upper and two lower. __________________ 54 Chevy Bel Air 4dr powerglide 54 Chevy SWB 58 Chevy Big Window SWB Fleetside project 58 Chevy LWB 235/4spd 76 Chevy Nova 350/TH350 4.88's *10kmiles on "new" engine 79 Chevy 4x4 SWB 350/4spd 3/4 ton 81 Mazda RX7 84 F@!d Mustang 96 F@!d Ranger 2.3L/5spd

04-27-2006, 07:11 PM	#4
dwcsr Hollister Road Co. Join Date: Apr 2005 Location: Houston Posts: 6,131	Re: Question: How bolts are holding the manual tranny to the bell housing? there are two inside the bell that are a pain in the A** to get at. and two on the outer top.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.