|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-22-2008, 06:38 PM
|
#1 |
|
On a budget like Fred Sanford
Join Date: Oct 2005
Location: Topeka, KS
Posts: 2,031
|
Where would I find......
.....angled shims that go under the leaf springs for correcting pinion angle? Mines like 5 degrees off and I'm sick of my teeth chattering on the highway.
__________________
'85 Silverado swb: 383 stroker, 10.5:1, vortec heads, 232/238 roller cam, RPM air gap, performer 750 carb, stainless longtubes, 3" duals/super 44's, T56/4.11 383ci build / exterior refresh thread '98 Camaro z28: 370ci twin turbo 370ci build '01 Tahoe LT 4x4: 5.3, longtubes/ory, magnaflow duals, custom tune....wife's DD Last edited by swb85; 03-22-2008 at 06:38 PM. |
|
|
|
03-22-2008, 06:50 PM
|
#2 |
|
On a budget like Fred Sanford
Join Date: Oct 2005
Location: Topeka, KS
Posts: 2,031
|
Re: Where would I find......
Never mind, found what I was looking for.
__________________
'85 Silverado swb: 383 stroker, 10.5:1, vortec heads, 232/238 roller cam, RPM air gap, performer 750 carb, stainless longtubes, 3" duals/super 44's, T56/4.11 383ci build / exterior refresh thread '98 Camaro z28: 370ci twin turbo 370ci build '01 Tahoe LT 4x4: 5.3, longtubes/ory, magnaflow duals, custom tune....wife's DD |
|
|
|
|
03-23-2008, 12:12 AM
|
#3 |
|
Registered User
Join Date: Jul 2007
Location: san antonio
Posts: 648
|
Re: Where would I find......
dont want to thread jack but how low does a truck have to be before shims are needed mine is 5/5 want 5/7 with 20's do i need shims or not................o yea 85 gmc sierra
|
|
|
|
|
03-23-2008, 01:12 AM
|
#4 |
|
On a budget like Fred Sanford
Join Date: Oct 2005
Location: Topeka, KS
Posts: 2,031
|
Re: Where would I find......
Hard telling, it's really easy to check your angles though. Just get a 10 dollar magnetic angle finder from the hardware store and check the transmission angle, driveshaft angle and pinion angle. You want ~5* pinion angle with leaf springs and the trans and pinion angle should match.
__________________
'85 Silverado swb: 383 stroker, 10.5:1, vortec heads, 232/238 roller cam, RPM air gap, performer 750 carb, stainless longtubes, 3" duals/super 44's, T56/4.11 383ci build / exterior refresh thread '98 Camaro z28: 370ci twin turbo 370ci build '01 Tahoe LT 4x4: 5.3, longtubes/ory, magnaflow duals, custom tune....wife's DD |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
