hurst shifter measurements

[Bama_C10]

we are going to put a floor mount hurst shifter(part# 501-0016) in our 62 c10 to do away with the tree shift.
anyone want to lend some measurements on where to cut the floor so as not to make a mess.I really appreciate it!!

[kdrodworks316]

I mounted mine but left the handle off, drilled a 1/4 hole from under the truck directly above the shifter, then a 2" hole with a hole saw. works great, clean, plenty of room and fits under the boot good. good luck

[MikeN]

Originally Posted by kdrodworks316

I mounted mine but left the handle off, drilled a 1/4 hole from under the truck directly above the shifter, then a 2" hole with a hole saw. works great, clean, plenty of room and fits under the boot good. good luck

This is exactly what I did. I then opened up the 2" hole slightly as needed with a die grinder.

[Bama_C10]

anyone with proper measurments from the front to back?

[Greg63]

I have a Muncie M-21 with a Hurst shifter. The hole for mine is probably different than where yours will be, but mine is at the rear of the center floor hump and it goes back toward the seat. I had to cut the vertical rise in the floor panel to make mine fit.
Greg

[64GMCHorsepower]

Is it direct linkage, or a cable hookup?

When I had my Hurst floor shifter, it was almost under the fornt seat.....