Steel floor in place of wood. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

hAetWagon · 09-12-2008, 02:12 AM

I'm sure it's been covered a million times, but I can't find a thread.
I plan on putting my truck on bags in the future so I need to plan ahead. I was originally going to replace the wood components in the bed but it'll be a wasted when it comes to time to Notch the frame and whatnot. Is there a thread out there? Have some of you done this? I can gather the process pretty easily but I figured I'd ask.
DO you retain the spars? Do you weld the bedsides on or bolt them?

09-12-2008, 02:12 AM	#1
hAetWagon Schlongbed MEMBER (heh)#15 Join Date: Jun 2005 Location: Sacramento Posts: 232	Steel floor in place of wood. I'm sure it's been covered a million times, but I can't find a thread. I plan on putting my truck on bags in the future so I need to plan ahead. I was originally going to replace the wood components in the bed but it'll be a wasted when it comes to time to Notch the frame and whatnot. Is there a thread out there? Have some of you done this? I can gather the process pretty easily but I figured I'd ask. DO you retain the spars? Do you weld the bedsides on or bolt them? __________________ 82 Chevy Blazer 4wd.RIP 1965 Chevy C10,350V8 Get it reliable,then puttin' it in the weeds.. "Old truck, all new headaches."

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.