|
10-14-2008, 12:30 PM
|
#1 |
|
Registered User
Join Date: Oct 2008
Location: rowlett tx
Posts: 37
|
Floor pans
I also have just bought a driver side floor pan for my 62 from LMC it was way over sized so is it ment to just cut out the rusted hole in the old floor and just patch because on the new one there is about a 6"lip on the out side of the pan that i have no idea where it goes it is in the down ward angle about a 45 degree angle and hits the door sill and kick panel any sugestions?
Last edited by boxer1381; 10-14-2008 at 12:31 PM. |
|
|
|
10-14-2008, 12:38 PM
|
#2 |
|
Ol' Blue Viking
Join Date: Nov 2006
Location: north of Baton Rouge
Posts: 172
|
Re: Floor pans
Are you doing rockers?
__________________
Driving Paw-paws truck into the Sunset! |
|
|
|
|
10-14-2008, 12:41 PM
|
#3 |
|
Registered User
Join Date: Oct 2008
Location: rowlett tx
Posts: 37
|
Re: Floor pans
My rocker are ok just got about a 8" rust hole in the floorboard bout half way between the fire wall and seat location
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
