|
07-10-2009, 02:49 PM
|
#1 |
|
Registered User
 
Join Date: Sep 2006
Location: Hendersonville, TN
Posts: 1,528
|
Panhard Bar bolt
I've got an ECE Super Track Bar that I'm going to install. As you know it uses a different mounting point. How do get the old panhard bar bolt out? I tried beating on it pretty good, but got nowhere. Does it come out? IF not, what are you doing with them.
__________________
BRENT  -'68 Stepside Project -'98 Z71 Daily Driver -Enough extra parts to build another truck and a half |
|
|
|
07-10-2009, 03:23 PM
|
#2 | |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: Panhard Bar bolt
I see that yo have the nut on the back side loose, have you tried to turn the stud with a pipewrench? It will come out, but it might take quite a bit of effort...cheater bar
"Fire"..........the old smoke wrench, will do it. Lacking that, BP blaster and patience, and maybe a small application of violence? Sawz-all and a drill are not out of the question either... There are enough options to keep you busy for a while 
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right.
|
|
|
|
|
|
07-11-2009, 03:41 PM
|
#3 |
|
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: Panhard Bar bolt
Agree, a pipe wrench will twist it right loose. It's worked every time for me.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
