|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-23-2009, 07:47 PM
|
#1 |
|
Registered User
Join Date: Nov 2006
Location: san diego, ca
Posts: 53
|
drop lca steering issues
I have a 60 with the 80 crossmember installed and added drop LCA's and lowering springs. My question is have any of you had issues with steering clearance using a stock spindle with this setup? Should i go back to the stock LCA's and get drop spindles instead?
|
|
|
|
11-23-2009, 09:25 PM
|
#2 |
|
Registered User
Join Date: May 2002
Location: NJ
Posts: 910
|
Re: drop lca steering issues
Not sure about your '60 setup but I didn't have any issues with my '83. I had drop LCAs and chopped springs.
Do you have everything installed?
__________________
83 C10 Stepside (SOLD, it was a blast!) 383 MASS-FLO EFI/TKO II 600/3.90 Posi 10 bolt S475 and C4 DM running, fine tuning turbo=  Douchebag Racing: Runs Fine all the Time |
|
|
|
|
11-23-2009, 09:36 PM
|
#3 |
|
Registered User
Join Date: Nov 2006
Location: san diego, ca
Posts: 53
|
Re: drop lca steering issues
i had it all mocked up to make sure i had enough clearance and it just doesn't seem correct. Thinking maybe i need the 80 pitman and idle arm. Because i think i still have the OG ones from my 60. If i could get a pic of someone else's setup maybe i could see what I am doing wrong.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
