![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Oct 2001
Location: Carrollton, GA
Posts: 57
|
350 Block and Crank - GA
I just pulled a complete 350 out of a yard truck. I needed the pistons and rods. Selling the block and crank. Never been machined. Mid 70's high nickel 010 2 bolt block with mains and crank.
I'm west of Atlanta. Make me an offer. peteyb@charter.net |
![]() |
![]() |
![]() |
#2 |
BAD BOW-Silverado XST
Join Date: May 2000
Location: Senior Member from Austin, TX
Posts: 6,431
|
Need anymore rods and pistons? I took some out of my 350 block GM crate block. They had about 84,000 miles on them. The owner sold me the block stating the engine had no power. I removed the heads and found a cracked valve. No damage to the piston or the cylinder wall. Must have been assembled that way.
![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Sep 2002
Location: portland tennessee
Posts: 36
|
LOCATION
HOW FAR ARE YOU FROM TENNESSEE? HOW MUCH ARE YOU ASKING?
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Oct 2001
Location: Carrollton, GA
Posts: 57
|
Not sure where you're at in Tenneseee, but figure the distance to Atlanta and add about 50 miles. I need to move this stuff so make me a decent offer.
We can probably even work out something to meet somewhere in the middle. email me at peteyb@charter.net |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|