|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-12-2001, 10:57 PM
|
#1 |
|
Account Suspended
Join Date: May 2000
Location: IL
Posts: 0
|
twopiece, I need to kow asap, so i can fix it
Why does my '76 GMC Sierra C-1500 have a two piece rear driveshaft ? Do the trucks with two piece shaft use the 6" tail tranny(TH350), or use the 9" tail truck tranny ? ? Can I replace the two piece with a one-piece shaft from a 78 C-10 with the same tranny, wheel base, and axle as the C-1500 ? The 76 C-1500 two piece shaft broke at the rear yoke, so.... I appreciate anything ! ------------------ -'77 Electra 403/TH350 -'76 GMC C-1500 Sierra Classic 350ci/TH350 -'68 C-10 chassis -'72 K-5 chassis Note: Looking for an S-10, Nova, Malibu, Monza, or similar for sale for around $1200 5652 posts 5-10-01 http://communities.msn.com/RandyR72K5 Randy Lincoln, IL "life's gonna leave me in the dust, if I don't try and catch up to it soon" r72k5@hotmail.com [This message has been edited by Fast68Chevy (edited 05-12-2001).] [This message has been edited by Fast68Chevy (edited 05-12-2001).] |
|
|
|
05-13-2001, 12:36 AM
|
#2 |
|
Oh,you can't buy that new
 
Join Date: Apr 2000
Location: Pennsville,N.J. 08070, USA
Posts: 2,039
|
Randy, it has something to do with the factory load capacity. Yes you can replace it with a one piece after removing the bearing support.My LWB one piecer has a 9" tail . the two piecers are much more forgiving to heavy loads and balance problems.DAVE
__________________
"been there, done that, ruined the T-shirt". 2007 LBZ GMC Sierra, ECSB 2006 LM7 RCSB Silverado 98 Vortec project. 94,3500,6.5L 4L80 81 SWB GMC POS finally gone  73 Pinto, stock, w/CragarSS's-eww  LOTS of Cummins trucks. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
