|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-08-2010, 07:30 PM
|
#1 |
|
Registered User
Join Date: Jan 2010
Location: San Jose, CA
Posts: 124
|
Got a problem need to find out how to deal with it
So I put my "new" hood on my truck today and when tightening up the bolts one of the "nuts" broke loose and now I can't finish tightening it. Any ideas on how to get to it with out messing up the hood????
Last edited by Russ65C10; 07-08-2010 at 07:31 PM. |
|
|
|
07-08-2010, 07:38 PM
|
#2 |
|
Registered User
Join Date: Aug 2005
Location: Pasadena,Tx /Pto Pta DR
Posts: 5,415
|
Re: Got a problem need to find out how to deal with it
I would use a small die grinder with cutoff wheel. I wouldn.t use a sawzall type saw.
|
|
|
|
|
07-08-2010, 07:44 PM
|
#3 |
|
Check The Champ, Demonstrator
 
Join Date: Jun 2009
Location: Montreal,Quebec
Posts: 6,627
|
Re: Got a problem need to find out how to deal with it
If you an loosen the bolts and remove them, try Permatex U-weld epoxy to glue the nut back in place. We did this on a Crown Vic hood and it worked well.
__________________
1963 Chevrolet Truck Literature LINK: https://picasaweb.google.com/113840717762774560215 YouTube Channel with 20+ Original Chevrolet Truck Salesmen, Mechanics & Service Department Training Slideshows. https://www.youtube.com/results?sear...otruk63&page=1 |
|
|
|
|
07-08-2010, 07:57 PM
|
#4 |
|
Registered User
Join Date: Aug 2009
Location: Grinnell iowa
Posts: 42
|
Re: Got a problem need to find out how to deal with it
take the hood back off flip it over cut a square shape around the hole weld the nut back and then the square piece and reinstall
__________________
66 chevy lwb 355/400 |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
