The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1947 - 1959 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 07-31-2010, 10:14 PM   #1
my51chevyrocks
Registered User
 
my51chevyrocks's Avatar
 
Join Date: Jun 2010
Location: Los Angeles, CA
Posts: 40
How much will it cost to convert my manual transmission to automatic

On my 51 Chevy Truck?
my51chevyrocks is offline   Reply With Quote
Old 07-31-2010, 10:27 PM   #2
tantrumpipeline
Master Procrastinator
 
tantrumpipeline's Avatar
 
Join Date: Sep 2009
Location: Grande Prairie AB Canada
Posts: 1,128
Re: How much will it cost to convert my manual transmission to automatic

that would depend on how, what tranny, column shift or floor shift auto, doing it yourself or paying a shop, type of rad you swap to etc, could be cheap or really expensive
__________________
My Buildhttp://67-72chevytrucks.com/vboard/s...d.php?t=395506
20 Duramax tow pig
68 2wd short stepper project
77 2wd short fleet beater
52 short project
tantrumpipeline is offline   Reply With Quote
Old 07-31-2010, 10:49 PM   #3
blackdiesel
Registered User
 
blackdiesel's Avatar
 
Join Date: Jan 2009
Location: Omaha, Arkansas
Posts: 929
Re: How much will it cost to convert my manual transmission to automatic

I changed one once, 800 rebiult tranny 200 floor shifter 50 to cut down driveshaft. your results may very.
__________________
'57 Chevy Pickup
'56 GMC LCF Cummins
'38 Chrysler Royal
'57 2wd change
http://67-72chevytrucks.com/vboard/s...light=speedway
blackdiesel is offline   Reply With Quote
Old 07-31-2010, 10:59 PM   #4
mr48chev
Registered User
 
mr48chev's Avatar
 
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,710
Re: How much will it cost to convert my manual transmission to automatic

There are lots of variables involved in doing this.

1. what engine do you have now?

2. are you intending to run the close driveline or switch to open drive?
This only applies if you have the original engine or a 235. With later engines it is far more prudent to swap rear ends.

If you had the stock engine and wanted to keep the stock driveline you would have to run a Hydromatic out of a 54 Pickup or maybe a powerglide out of a 53 or 54 car (and I don't know if that will fit) as they are about the only options. Both would make it a real slug with a stock 216. More so than it is now. Both can be expensive to repair as you are hitting the vintage transmission area.

If you have a V8, 230,250 or late 292 six then you can bolt on a powerglide, turbo 350, 400 or other trans that matches up with the engine. Then it is a straightforward trans and rear end swap.
mr48chev is offline   Reply With Quote
Old 08-01-2010, 09:56 AM   #5
raycow
Registered User
 
Join Date: Mar 2003
Location: San Francisco, CA USA
Posts: 2,454
Re: How much will it cost to convert my manual transmission to automatic

Adding to mr48chev's post, there is one other option you might want to know about. You can get a commercial adapter plate that will allow you to bolt a modern automatic to a 216, 235, or 261.
http://www.stoveboltengineco.com/aca...?productid=168

Naturally, you would also have to change to open drive, replace the rear end, and convert to 12 volts (for the starter).

Please don't think that I am advocating this route, because you could install a 230, 250, or 292 for no more work or money than the adapter would involve, and I feel the later engine would be a better choice. However, I just wanted to make sure you were aware of what else was out there.

Ray

Last edited by raycow; 08-01-2010 at 10:18 AM.
raycow is offline   Reply With Quote
Old 08-01-2010, 07:02 PM   #6
mr48chev
Registered User
 
mr48chev's Avatar
 
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,710
Re: How much will it cost to convert my manual transmission to automatic

I did find the link to the trans mounted neutral safety switch I was thinking about.
http://www.ronfrancis.com/products.asp?dept=35

I would imagine that several sources sell a similar switch setup. That would probably be the simplest and easiest way out on the shifter/neutral switch thing.
mr48chev is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:38 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com