|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-09-2010, 01:45 AM
|
#1 |
|
Registered User
Join Date: Mar 2010
Location: los angeles, CA
Posts: 1
|
crossmember swap '64 into '60
hello, first post here. lots of good info here but i still can't find what i'm looking for. i scored a '64 front end for $40 and put it into my '60. i got 2 bolts per side to line up (the front lower frame bolts) and thats it. now before i start oblonging and drilling holes in my frame can someone tell me if these are the right holes to index the others from? i thought i saw a post somewhere about this but can't find it now. thanks in advance. mark
p.s.- its going to be bagged and very low Last edited by hoodrat; 10-09-2010 at 02:47 AM. Reason: idiot (me) cant spell |
|
|
|
10-09-2010, 06:13 AM
|
#2 |
|
Registered User
Join Date: Mar 2003
Location: San Francisco, CA USA
Posts: 2,454
|
Re: crossmember swap '64 into '60
If it were mine, I would make sure the wheels were centered in the fender openings and not worry about which holes line up.
Ray |
|
|
|
|
10-09-2010, 08:19 AM
|
#3 |
|
One day...
 
Join Date: Apr 2008
Location: Tuttle, Ok
Posts: 9,243
|
Re: crossmember swap '64 into '60
I put a 74 cross member in mine and had to drill the frame for it to work and do like raycow said then punch some holes and you should be good.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
