The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 08-31-2013, 08:40 PM   #1
mooseknuckles
Registered User
 
mooseknuckles's Avatar
 
Join Date: Sep 2009
Location: ottawa,canada
Posts: 4,550
4l80 nss wiring

I have a lokar led PRND dash indicator....can I wire it to use the 4l80e neutral safety switch? .....does anyone have a wiring diagram for the nss?
Attached Images
  
mooseknuckles is offline   Reply With Quote
Old 09-01-2013, 01:57 AM   #2
dayj1
Senior Member
 
Join Date: Jul 2009
Location: Athens, AL
Posts: 499
Re: 4l80 nss wiring

Quote:
Originally Posted by mooseknuckles View Post
I have a lokar led PRND dash indicator....can I wire it to use the 4l80e neutral safety switch?
I used one of the Lokar indicators for a LS swap in a Jeep YJ. It is possible to wire it to the 4L60/80 indicator switch, but it isn't as easy as just hooking up a few wires.

The Lokar indicator is a simple device. It is just 7 LEDs with all the cathodes tied together through a current limiting resistor. The anodes of the LEDs are separate and there is a dedicated wire for each gear LED. Supply 12 volts to the appropriate wire, and the LED lights. You can test it on the truck battery to see what I mean.

Unfortunately, the indicator switch on the transmission uses 4 signal wires to send the gear information to the PCM. In other words, the indicator switch switches ground and 12 volts on 4 signal wires in various combinations to indicate the gear. It's easy enough to switch though the gears (with the ignition on but the vehicle not running) while checking the signal wires with a logic probe or volt meter. Then you can just make a table of the values to decode the signal.

There are 2 "easy" ways to decode the signal from the 4 signal wires to the 7 wires going to the Lokar indicator.

Option 1:
A circuit built around a 3 to 8 decoder/demultiplexer IC.

Option 2:
A relay tree.

Either option will require a small circuit board to be built. If you're not handy with a soldering iron, it probably makes more sense to just buy the Lokar controller. If this sounds like something that you want to try, let me know and I'll see if I can dig up my notes and post a schematic for you.
dayj1 is offline   Reply With Quote
Old 09-01-2013, 09:14 AM   #3
mooseknuckles
Registered User
 
mooseknuckles's Avatar
 
Join Date: Sep 2009
Location: ottawa,canada
Posts: 4,550
Re: 4l80 nss wiring

thanks for the info!......I think I'll just buy the lokar sensor....lol.
mooseknuckles is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:47 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com