|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-13-2014, 03:49 PM
|
#1 |
|
Registered User
Join Date: Dec 2012
Location: Bangor, Michigan
Posts: 375
|
Flare - Start flasher switch dilemma.
Alright so I purchased a flasher switch from a local boneyard that was in an old 64 GMC flatbed 1 ton and want to wire it into my truck. I took a picture of it before I removed it from the wiring harness and tried to re wire it the same way as the Jimmy was. Unfortunately it only works when I had the ignition on and turn signal on. Couldn't find a good source of constant power to wore the fusible link into. Any suggestions or advice?
__________________
That's the thing about a Chevrolet, no matter how they look, whether it be a trailer queen or a good ol' used farm truck, no other truck on the road will always look that damn good wearing a Bowtie. |
|
|
|
02-13-2014, 04:37 PM
|
#2 |
|
Check The Champ, Demonstrator
 
Join Date: Jun 2009
Location: Montreal,Quebec
Posts: 6,627
|
Re: Flare - Start flasher switch dilemma.
__________________
1963 Chevrolet Truck Literature LINK: https://picasaweb.google.com/113840717762774560215 YouTube Channel with 20+ Original Chevrolet Truck Salesmen, Mechanics & Service Department Training Slideshows. https://www.youtube.com/results?sear...otruk63&page=1 |
|
|
|
|
02-13-2014, 10:17 PM
|
#3 |
|
Registered User
Join Date: Dec 2012
Location: Bangor, Michigan
Posts: 375
|
Re: Flare - Start flasher switch dilemma.
Thanks AeroTruck. That helped a lot!
__________________
That's the thing about a Chevrolet, no matter how they look, whether it be a trailer queen or a good ol' used farm truck, no other truck on the road will always look that damn good wearing a Bowtie. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
