17" steel chevy wheel

[jtrichard]

Hi has any one used these wheels and how did they fit? trying to use them on a 63 http://67-72chevytrucks.com/vboard/a...mentid=1271853

[Palf70Step]

Those look like the Toyota FJ wheels. I know someone ran them on a 69 model, but can't remember if he ran a spacer or not.

Found it: Member is TCB-1
Toyota FJ Cruiser rims, 17" x 7.5" wide on a 6 x 5.5" bc. I'm running a .75 spacer on them now, but may take them off when I lower it

[PGSigns]

Not sure on those wheels as to what they are. Easy enough to measure the back spacing. The one thing you will run into with many late model wheels is the diameter of the hole in the center of the wheel. I pulled my rear axles and turned them down on the end to 3.06 I think to allow the wheel to go over the end of the axle. My front was fine with the late model disc brakes on it.
Jimmy

[rickywideglide]

Originally Posted by jtrichard

Hi has any one used these wheels and how did they fit? trying to use them on a 63 http://67-72chevytrucks.com/vboard/a...mentid=1271853

they look like late model gm wheel, center bore way to small

[61K10]

If they are FJ 17" wheels they have a big center hole. had them on my k10 when i bought it. the other ones as ricky said the center hole is too small. Look at how far the lug nuts holes are from the center hole edge. the FJ's are right at the edge.