|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-01-2015, 07:06 PM
|
#1 |
|
Registered User
Join Date: Feb 2010
Location: San Angelo, Tx
Posts: 1,068
|
Glove box door question for a TF.
Today I stripped my glove box door in preparation for painting.
It has a large dent in the middle that was filled with bondo a little over 1/4" deep. I want to replace this rather than spending the time it would take to repair it. I was looking and there is a repro available made by Dynacorn for $80 from a few vendors. Anybody with experince on how they fit? If they don't fit that well, I'll start searching for a good used original. Thanks! |
|
|
|
02-01-2015, 07:36 PM
|
#2 |
|
Registered User
Join Date: Jan 2012
Location: Motown
Posts: 7,680
|
Re: Glove box door question for a TF.
$80 buys a lot of filler
 throw a couple screw in it and pull the dent
__________________
cool, an ogre smiley Ogre's 58 Truk buildhow to put your truck year and build thread into your signature shop air compressor timer |
|
|
|
|
02-01-2015, 07:39 PM
|
#3 | |
|
Registered User
Join Date: Feb 2010
Location: San Angelo, Tx
Posts: 1,068
|
Re: Glove box door question for a TF.
Quote:
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
