separating transmission - The 1947 - Present Chevrolet & GMC Truck Message Board Network

class01 · 03-22-2015, 10:20 PM

Trying to separate my 6l80 transmission from the motor. Got all the bolts on the case out anything else i need to do because its not budging.

clinebarger · 03-22-2015, 11:41 PM

Remove the torque converter bolts! There are 2 bellhousing bolts into the oil pan, And 6 in the block.

The trans is stuck on the Dowel Pins, Very common issue, One or both will come out of the block with the trans, Rock the trans side to side, Then up & down.

class01 · 03-23-2015, 10:13 AM

thanks clinebarger. I knew i had to be missing something

03-22-2015, 10:20 PM	#1
class01 Registered User Join Date: Jul 2007 Location: Utah Posts: 295	separating transmission Trying to separate my 6l80 transmission from the motor. Got all the bolts on the case out anything else i need to do because its not budging.

03-22-2015, 11:41 PM	#2
clinebarger Senior Member Join Date: May 2009 Location: Fort Worth, TX Posts: 6,370	Re: separating transmission Remove the torque converter bolts! There are 2 bellhousing bolts into the oil pan, And 6 in the block. The trans is stuck on the Dowel Pins, Very common issue, One or both will come out of the block with the trans, Rock the trans side to side, Then up & down.

03-23-2015, 10:13 AM	#3
class01 Registered User Join Date: Jul 2007 Location: Utah Posts: 295	Re: separating transmission thanks clinebarger. I knew i had to be missing something

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.