Anyone willing to provide the following measurements for GMC Dash (pic included)

[siggyfreud]

Starting the design phase of a replacement GMC dash bezel. I'll either be printing one, or milling it from block plastic.

I don't have access to one currently or else this would be a lot easier .

Would anyone be willing to provide the 1-8 measurements for me based on the pic below? #8 is a depth measurement. These should get me in the ballpark so in the next few weeks I can route these from cheap wood for test fitting/adjustment.

1. Inside measurement bottom to beginning of top curve.
2. Inside height measurement at end of curve.
3. Inside height center.
4. Outside height, edge to edge.
5. Inside width bottom.
6. Inside width start of curve.
7. Inside width top where curve ends.
8. Depth



If anyone in the Portland area has one I could borrow for a couple of weeks that would also work swimmingly .

Cheers all!