|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-11-2016, 06:56 PM
|
#1 |
|
Registered User
Join Date: Nov 2014
Location: Fort Worth
Posts: 7
|
Vortec with POL Mounts
Hello all,
Ran into an issue mounting my vortec engine with POL engine and tranny mounts. While the engine mounted up fine, the gap between the transmission and the mount is to much to get the bolts in place. See it here..  Anybody ran into this issue and know of a solution? Much thanks |
|
|
|
04-12-2016, 07:48 AM
|
#2 |
|
Senior Member
 
Join Date: Sep 2005
Location: Lewisville, Nc
Posts: 10,237
|
Re: Vortec with POL Mounts
Flip the cross member?
__________________
David fuller Ase Certified Mechanic Click here to help support our board!! 1971 Chevy c-10 under going a 4.8l LSx swap Build Thread http://67-72chevytrucks.com/vboard/s...d.php?t=421305 2007 Honda Accord my daily 145kmiles 2002 Honda Accord 4 door With 330k(sisters car) 2005 toyota Avalon 228k( brothers car) 2002 Sububran 5.3 245k 2000 Tahoe 5.3l 378 General manager for Marco's Carwash & lube |
|
|
|
|
04-12-2016, 08:36 AM
|
#3 |
|
Registered User
Join Date: Nov 2014
Location: Fort Worth
Posts: 7
|
Re: Vortec with POL Mounts
Tried that. Then the mount is to high!
|
|
|
|
|
04-12-2016, 03:52 PM
|
#4 |
|
1965 Chevy C10, 2005 4.8L/4l60
 
Join Date: Aug 2004
Location: DFW Texas
Posts: 8,546
|
Re: Vortec with POL Mounts
I used the CPP trans mount with POL Engine mounts( Perches).
__________________
Clyde65 Rebuild of Clyde http://67-72chevytrucks.com/vboard/s...84#post8338184 69 Aristocrat Lo Liner build http://67-72chevytrucks.com/vboard/s...84#post7561684  support our troops! |
|
|
|
|
04-12-2016, 04:05 PM
|
#5 |
|
Registered User
Join Date: Oct 2013
Location: Alabama
Posts: 1,234
|
Re: Vortec with POL Mounts
I would start by contacting POL.
|
|
|
|
|
04-12-2016, 07:43 PM
|
#6 |
|
meowMEOWmeowMEOW
Join Date: Sep 2009
Location: MKE WI
Posts: 7,128
|
Re: Vortec with POL Mounts
Have you measured the angle on the engine at all? I'm just wondering the gap in relation to the angle of the motor (flat, leaned forward or leaned back in *'s)
__________________
'66 Short Step / SD Tuned / Big Cam LQ4 / Backhalfed /Built 4l80e / #REBUILDEVERYTHING  |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
\\ MY YOUTUBE CHANNEL
Linear Mode
