|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-28-2016, 07:23 AM
|
#1 |
|
Registered User
Join Date: Aug 2007
Location: charlestown maryland
Posts: 272
|
C10 vs c20 front crossmembers are they the same?
I want to section a crossmember for my c20 so I have it ready for when I swap the engine in a couple months. I can't find a definitive answer on if the c10 crossmembers are the same as a c20. I have access to a lot more c10 parts than c20. Anyone know for sure? I know the c20 uses larger u bolts on the lower arms but can I just drill those larger?
|
|
|
|
04-28-2016, 09:49 AM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,068
|
Re: C10 vs c20 front crossmembers are they the same?
Lower shaft u-bolts aren't different. The upper shaft studs are 9/16" for C20/30 & 1/2" for C10's. The x-members will interchange but will require using the correct upper arms for the specific x-member.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
04-28-2016, 12:10 PM
|
#3 |
|
Registered User
Join Date: Aug 2007
Location: charlestown maryland
Posts: 272
|
Re: C10 vs c20 front crossmembers are they the same?
Can i just drill them out and run grade 8 bolts and put the 3/4 ton arms on when I swap them?
|
|
|
|
|
04-28-2016, 01:05 PM
|
#4 | |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,068
|
Re: C10 vs c20 front crossmembers are they the same?
Quote:
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
