Blazer Tailgate Moulding Holes

[phillipm]

I'm getting ready to install the last two pieces of trim on our Blazer. So far I've been referencing a drawing that was posted on here of a 77 C10 for my holes and placements. However, with the Blazer gate being so different I've noticed that those #s don't make sense for this piece. My question is, can someone tell me how far from the left and right edge of the gate the push clip holes should be drilled?

[phillipm]

No ones got a gate with the trim off that they could measure or take a pic of with a tape measure held up to it??

[68Timber]

My 79 has the trim already removed, sorry

[lolife99]

Originally Posted by phillipm

No ones got a gate with the trim off that they could measure or take a pic of with a tape measure held up to it??

Does this help?
Not mine,....

[phillipm]

Thanks Keith. I needed to know how far those holes were from the edge so just a pic doesn't help much. I ended up drilling them at 1.25" from the edge and didn't hit anything on the inside... so, not sure if that info helps anyone else in the future but I'll just leave that here! Haha.

[lolife99]

I was hoping you could get a good guess from the picture.
Width of trim shadow vs distance from the edge,...