|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-03-2017, 11:51 PM
|
#1 |
|
Registered User
Join Date: Nov 2016
Location: Lunenburg Ma
Posts: 52
|
Porterbuilt engine mounts
I’m running the gen 1 pbfab dropmember And Just decided to ls swap. The engine mounts pbfab sent me are offset to allow room to run the factory a/c compressor. So the whole motor and trans is off to the passenger side. Now the trans mounts doesn’t line up with the pbfab tranny mount. So do I just ratchet strap it over ?
Posted via Mobile Device |
|
|
|
11-03-2017, 11:53 PM
|
#2 |
|
Registered User
Join Date: Nov 2016
Location: Lunenburg Ma
Posts: 52
|
Posted via Mobile Device
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
