|
04-01-2019, 09:50 PM
|
#1 |
|
Registered User
 Join Date: Dec 2018
Location: Carnation, WA.
Posts: 258
|
New cab bushings ???
Took out original bolts to start replacing and the two back bolts were bent at about 15-20 degrees. Any thoughts ????
|
|
|
|
04-01-2019, 10:15 PM
|
#2 |
|
Senior Member
Join Date: Nov 2018
Location: Waterford California
Posts: 2,656
|
Re: New cab bushings ???
15 to 20 degrees is a lot of deflection, sounds like a broadside job at one time, but then again if I remember those are about 7/16 to 1/2" bolts...pretty stout.
|
|
|
|
|
04-01-2019, 10:19 PM
|
#3 |
|
Registered User
Join Date: Dec 2018
Location: Carnation, WA.
Posts: 258
|
Re: New cab bushings ???
What do u mean "broadside job" ?
|
|
|
|
|
04-01-2019, 10:19 PM
|
#4 |
|
Registered User
Join Date: Jun 2018
Location: EL PASO
Posts: 96
|
Re: New cab bushings ???
Had to be an accident at some point. As in something has hit the cab hard enough to bend them or hit the frame hard enough to bend them. Only other way is someone put used bent bolts in at some point. Who knows.
|
|
|
|
|
04-01-2019, 10:23 PM
|
#5 |
|
Registered User
Join Date: Dec 2018
Location: Carnation, WA.
Posts: 258
|
Re: New cab bushings ???
Makes sense but it would have to have been something that did not mess up the frame as it shows no type of damage as I have the motor, tranny and the bed off.
|
|
|
|
|
04-01-2019, 10:26 PM
|
#6 |
|
Registered User
Join Date: Dec 2018
Location: Carnation, WA.
Posts: 258
|
Re: New cab bushings ???
One of those thing that make you think whether to scratch your head or butt.
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
