Lifted '79 K-5 Blazer Cheyenne 3/4-ton F/S - The 1947 - Present Chevrolet & GMC Truck Message Board Network

doc70sub · 11-29-2003, 11:25 AM

Selling my '79 K-5:
-4" lift
-3/4-ton drivetrain
-A/C (compressor removed, but included)
-power doors & rear gate & Cruise Control
-nice factory bucket & rear seats
-Factory tach dash w/ good Black pad
-Factory rear roll bar
-SB (factory 400, but may have been switched to 350) 4-bbl, TH-350 (rebuilt in the last 15,000 miles), 203
-cab rusty along the a-piller, floors are good, quarters bad..
-topper good w/ sliders
-Factory black w/ burgandy interior
-ran last winter, carb acting up, replaced full pump before found to be carb....does not run
-cut out cats, easy to put back (included)
-clear title

-Savable as is, swap a truck cab on, or great parts truck

$800 w/o wheels/tires

Thanks!
Doc

leadfoot067 · 11-29-2003, 03:07 PM

did ya post this on coloradok5.com? you should....

doc70sub · 11-29-2003, 09:22 PM

YUP!

Posted there first...
Doc

Destructo · 11-29-2003, 10:49 PM

Why ya selling the blazer? If ya don't mind me asking of course! Keeping the burb?

doc70sub · 11-30-2003, 03:31 AM

Keeping the 'Burban.......

I'm just trying to consolidate into one 3/4-ton 4wd & the Sub as my only rides.....& the 'Stang of course! LOL

Doc

Destructo · 11-30-2003, 11:48 AM

Makes good sense hehe. Kinda hard to keep up a lot of vehicles.

chevykid1969 · 12-01-2003, 08:02 PM

I am intrested. How does it run? do you think it could work as a daily driver for a while?

doc70sub · 12-01-2003, 08:29 PM

Replace/rebuild carb, tune it up, & I do not see why not.....
Doc

doc70sub · 12-02-2003, 08:07 PM

Truck still available.....

chevykid1969 · 12-02-2003, 08:08 PM

Darn!

doc70sub · 12-20-2003, 12:24 AM

Truck available, sold truck I needed the axle for....anyone interested?

Thanks!
Doc

11-29-2003, 11:25 AM	#1
doc70sub Registered User Join Date: Dec 2000 Location: Thomasville, NC Posts: 669	Lifted '79 K-5 Blazer Cheyenne 3/4-ton F/S Selling my '79 K-5: -4" lift -3/4-ton drivetrain -A/C (compressor removed, but included) -power doors & rear gate & Cruise Control -nice factory bucket & rear seats -Factory tach dash w/ good Black pad -Factory rear roll bar -SB (factory 400, but may have been switched to 350) 4-bbl, TH-350 (rebuilt in the last 15,000 miles), 203 -cab rusty along the a-piller, floors are good, quarters bad.. -topper good w/ sliders -Factory black w/ burgandy interior -ran last winter, carb acting up, replaced full pump before found to be carb....does not run -cut out cats, easy to put back (included) -clear title -Savable as is, swap a truck cab on, or great parts truck $800 w/o wheels/tires Thanks! Doc Attached Images __________________ 1970 Sub C-10 - 350/TH-350/3.73 12-bolt Came home from the hospital in it & mine ever since. 1966 Catalina Ventura 2-door fastback 389/TH400 Last edited by doc70sub; 12-28-2003 at 11:33 PM.

11-29-2003, 03:07 PM	#2
leadfoot067 horsepower junkie Join Date: Aug 2003 Location: graham, washington Posts: 326	did ya post this on coloradok5.com? you should.... __________________ 67 short wide box,350/700r4/3.73posi 71 olds cutlass "S" mom bought new..12.30s@113MPH

11-29-2003, 09:22 PM	#3
doc70sub Registered User Join Date: Dec 2000 Location: Thomasville, NC Posts: 669	YUP! Posted there first... Doc __________________ 1970 Sub C-10 - 350/TH-350/3.73 12-bolt Came home from the hospital in it & mine ever since. 1966 Catalina Ventura 2-door fastback 389/TH400

11-30-2003, 03:31 AM	#5
doc70sub Registered User Join Date: Dec 2000 Location: Thomasville, NC Posts: 669	Keeping the 'Burban....... I'm just trying to consolidate into one 3/4-ton 4wd & the Sub as my only rides.....& the 'Stang of course! LOL Doc __________________ 1970 Sub C-10 - 350/TH-350/3.73 12-bolt Came home from the hospital in it & mine ever since. 1966 Catalina Ventura 2-door fastback 389/TH400

12-01-2003, 08:29 PM	#8
doc70sub Registered User Join Date: Dec 2000 Location: Thomasville, NC Posts: 669	Replace/rebuild carb, tune it up, & I do not see why not..... Doc __________________ 1970 Sub C-10 - 350/TH-350/3.73 12-bolt Came home from the hospital in it & mine ever since. 1966 Catalina Ventura 2-door fastback 389/TH400

11-29-2003, 10:49 PM	#4
Destructo Registered User Join Date: Sep 2003 Location: Lewisville, NC Posts: 1,836	Why ya selling the blazer? If ya don't mind me asking of course! Keeping the burb?

11-30-2003, 11:48 AM	#6
Destructo Registered User Join Date: Sep 2003 Location: Lewisville, NC Posts: 1,836	Makes good sense hehe. Kinda hard to keep up a lot of vehicles.

12-01-2003, 08:02 PM	#7
chevykid1969 Registered User Join Date: Apr 2003 Location: Knightdale,North Carolina Posts: 377	I am intrested. How does it run? do you think it could work as a daily driver for a while?

12-02-2003, 08:07 PM	#9
doc70sub Registered User Join Date: Dec 2000 Location: Thomasville, NC Posts: 669	Truck still available..... __________________ 1970 Sub C-10 - 350/TH-350/3.73 12-bolt Came home from the hospital in it & mine ever since. 1966 Catalina Ventura 2-door fastback 389/TH400 Last edited by doc70sub; 12-20-2003 at 12:23 AM.

12-02-2003, 08:08 PM	#10
chevykid1969 Registered User Join Date: Apr 2003 Location: Knightdale,North Carolina Posts: 377	Darn!

12-20-2003, 12:24 AM	#11
doc70sub Registered User Join Date: Dec 2000 Location: Thomasville, NC Posts: 669	Truck available, sold truck I needed the axle for....anyone interested? Thanks! Doc __________________ 1970 Sub C-10 - 350/TH-350/3.73 12-bolt Came home from the hospital in it & mine ever since. 1966 Catalina Ventura 2-door fastback 389/TH400

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.