GMC turn signal removal - The 1947 - Present Chevrolet & GMC Truck Message Board Network

rustyrodknocker · 10-12-2019, 07:12 PM

Hello all,
I don't know what I'm missing here. Im trying to remove the lights from my GMC hood in order to paint it. I can't find any fasteners. In the back there are two square nuts with nothing in them. The front has the factory riveted lens.
I'm about to cut the lens out with a grinder or something.
Can somebody enlighten me?

**Rolland** · 10-12-2019, 11:19 PM

Look behind the steel housing and you will see 4 tabs, 2 above and 2 below, which lock it in place. With a suitable screwdriver, release the 2 upper tabs and push out the housing slightly. Then do the same with the lower tabs and push the housing out the front.

10-12-2019, 07:12 PM	#1
rustyrodknocker Registered User Join Date: Dec 2010 Location: salem oregon Posts: 414	GMC turn signal removal Hello all, I don't know what I'm missing here. Im trying to remove the lights from my GMC hood in order to paint it. I can't find any fasteners. In the back there are two square nuts with nothing in them. The front has the factory riveted lens. I'm about to cut the lens out with a grinder or something. Can somebody enlighten me?

10-12-2019, 11:19 PM	#2
Rolland Senior Member Join Date: Mar 2014 Location: Colorado Springs CO Posts: 215	Re: GMC turn signal removal Look behind the steel housing and you will see 4 tabs, 2 above and 2 below, which lock it in place. With a suitable screwdriver, release the 2 upper tabs and push out the housing slightly. Then do the same with the lower tabs and push the housing out the front.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.