|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-07-2020, 04:23 AM
|
#1 |
|
Registered User
Join Date: Dec 2011
Location: Belgium
Posts: 82
|
advice needed : is there a good or bad for connecting pully's on a SBC350
Now that we’re in lockdown in most of Europe, I jumped on the Chevy project again …
Installed the engine (SBC350) and now wanna install the v-belts… I only need to connect 4 pully’s : crank, water pump, power steering pump and alternator. Is there a proper way of connecting them ? Should I do it with 1 belt, or more ? Or is it just a matter of getting them turning…
__________________
'56 Chevy stepside shortbed SBC350 - TH350 12-bolt rear |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode