88&up front end parts on 87&down 2wd - The 1947 - Present Chevrolet & GMC Truck Message Board Network

corn · 12-12-2003, 11:30 PM

I have an '84 GMC 2wd & have a set of '88 & up drop spindles & also a complete '94 front end. Is there a way to use the newer drop spindles on my '84?

New Guy=Dumb Questions...corn

tommie · 12-15-2003, 05:17 PM

sounds too hard.

i am sure that there is a way that it can be done, but it would be eiasier to just sell the 88' up spindles and buy some spindles for your 84'

corn · 12-15-2003, 06:46 PM

Thats what I was afraid of. Thanks

12-12-2003, 11:30 PM	#1
corn Registered User Join Date: Dec 2003 Location: here Posts: 5,789	88&up front end parts on 87&down 2wd I have an '84 GMC 2wd & have a set of '88 & up drop spindles & also a complete '94 front end. Is there a way to use the newer drop spindles on my '84? New Guy=Dumb Questions...corn

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-15-2003, 05:17 PM	#2
tommie 97' Tahoe 2dr/2wd Join Date: Jul 2002 Location: Huffman,TX Posts: 1,168	sounds too hard. i am sure that there is a way that it can be done, but it would be eiasier to just sell the 88' up spindles and buy some spindles for your 84'

12-15-2003, 06:46 PM	#3
corn Registered User Join Date: Dec 2003 Location: here Posts: 5,789	Thats what I was afraid of. Thanks



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.