|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-01-2021, 03:27 PM
|
#1 |
|
Registered User
Join Date: Jun 2014
Location: upstate sc
Posts: 2,095
|
Wheel opening moldings
I did a search and no definitive answer so here goes...
Who sells the best moldings and are there multiple manufacturers or does everyone sell the same stuff Thanks for the help |
|
|
|
08-02-2021, 09:58 AM
|
#2 |
|
Robert Olson Transport
 
Join Date: Oct 2002
Location: recent transplant to NC USA
Posts: 20,310
|
Re: Wheel opening moldings
the LMC ones arent bad ive used them several times for different builds
__________________
Bob 1951 International running on a squarebody chassis "If a man's worth is judged by the people he associates himself with, then i am the richest man in the world knowing some of the fine people of this board" http://67-72chevytrucks.com/vboard/a...t.php?f=25&a=9 (you can review the site rules here!) PM Me for your vehicle/parts hauling needs in the North East US or see my Facebook page Robert Olson Transport Live each day to the fullest.. you never know when fate is going to pull the rug out from under you... I hate cancer!! |
|
|
|
|
08-02-2021, 04:23 PM
|
#3 |
|
Senior Member
 
Join Date: Jun 2015
Location: Atlanta, GA.
Posts: 737
|
Re: Wheel opening moldings
LMC ones are ok. Some screw holes lined up, some didn't. Fit is good though.
__________________
Jay Gesner Atlanta, GA 1985 C10 Long Bed 4X2 LS 5.3, 4L60E Father/Daughter Project |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
