Power Window Regulator...Help

[cfan10]

Ok, these are power but truck wiring isn't complete so the windows have no power. If I get the glass on the two regulator connections and door tab connection, I can only get one bolt to fit in door. Extremely frustrating.

'84 c10

As always thanks in advance for your help, it is greatly appreciated!!!

[Pontiac1976]

Hello there I had Manual Regulators in my truck was adding Power Regulators But been some time since I seen them bolted in but. I think there is only 3 or 4 bolt on the power Regulators If I remember right. But there is a power REG. bracket holds the holds the power motor and bolt to the REG. If you do not have that bracket then you may only get one or two bolts to line up. I hope this helps you a bit. If you lookat LMC on line catalog around pg70 you can see the two Regulators and the motor bracket.

[cfan10]

Thanks a bunch I disassembled the passenger door panel trying to compare.

[Pontiac1976]

Oh I believe it helps to slide the rollers in the slider channels first, but you may need to have a jumper power 12Volt (-/+), wire to the motor to move the REG. to the best spot line up the holes and the rollers in the slider( but be careful of fingers)