|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-11-2022, 08:12 PM
|
#1 |
|
Registered User
Join Date: Apr 2005
Location: Austin, Texas
Posts: 300
|
Does anyone make a stock height progressive rate coil spring?
I've got 2.5" drop spindles and 1 or 2" drop springs in the front and had 4" rear springs. I replaced the rears with some 3" springs but the front us just too low. I'm not a fan on the rake.
I have Eibach lowering springs in the front now and love the way they ride and handle but they don't offer a stock height spring. Anyone offer a progressive rate stock height spring for a 66 C10?
__________________
My mother is a recent cancer survivor and this truck build is for her |
|
|
|
04-12-2022, 12:05 AM
|
#2 |
|
Senior Member
   
Join Date: Jan 2018
Location: Hickory Flat, GA
Posts: 4,491
|
Re: Does anyone make a stock height progressive rate coil spring?
For the front? I haven't seen one for the front that's stock height.
If you can't find what you're looking for on the front springs, you could use some drop blocks in the rear if you haven't done that already
__________________
Christian Carpenter 1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
