|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
11-28-2012, 01:44 AM
|
#1 |
|
Registered User
Join Date: Feb 2012
Location: Big Valley. Alberta
Posts: 674
|
Re: anybody used this trans?
Ok,that makes sense with your speed limit.No so much a pulling thing,more so getting the cummins rpm down to a good fuel economy range....
Posted via Mobile Device
__________________
1977 Chev C30 454/465/14ff DRW 1974 Chev C20.350/465/14ff " Rock n Roll ain't noise pollution" 
|
|
|
|
11-29-2012, 10:34 PM
|
#2 |
|
Registered User
Join Date: Feb 2012
Location: Big Valley. Alberta
Posts: 674
|
Re: anybody used this trans?
If your gross vehicle weight is over 25,000lbs in a 1 ton or smaller truck,the last thing I would worry about is the ranger unit.If your hauling that much weight,better look at a lot bigger towing truck first!! Like something in a single axle highway truck.See it lots up here too,sure that diesel 3/4 ton- 1 ton will pull that big flatbed,but controlling it is another thing sometimes.....
Posted via Mobile Device
__________________
1977 Chev C30 454/465/14ff DRW 1974 Chev C20.350/465/14ff " Rock n Roll ain't noise pollution"
|
|
|
|
|
11-30-2012, 12:43 PM
|
#3 |
|
Registered User
Join Date: Mar 2012
Location: edgartown mass
Posts: 852
|
Re: anybody used this trans?
only bad thing that i have heard of on the gv is the elc controls like to quit if you set it up with there stuff to auto maticly shift in
any truth to that?
__________________
1986 c20 "the hillbilly" 350 sm465 3.42gears 21mpg at 70mph 1985 k30 "the ice cream truck from hell" no rust az truck 197-8??? c30 "ramp truck" 454 1978 monte carlo 350 350th with 2.73 gears. no rust. sc car |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
