Flip kit? + Shackles? How low can I go in the back. - Page 3 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

knightlife · 06-12-2007, 08:43 PM

I use the "Toxic Shox" that I found on stylin concepts...they work pretty smooth

SCOTI · 06-12-2007, 10:50 PM

Quote:

Originally Posted by bigblock73

It might depending on the rear leaf spring length. My 73 has HD leafs (56" I believe), I trimmed mine based off Bell Tech's instructions, but by the looks of it, they would have been behind the bed support anyhow. I can almost guarantee if I had 52" leafs, I'd have to trim.

I wish my truck was still here, I'd go snap a pic.

That's prob it.... HD vs. LD spring length. Mine is HD 8-leaf pack.

Mr79C10 · 06-13-2007, 11:22 AM

Can a leaf be added to "stiffin" up a bit?

randyjohn · 06-20-2007, 09:14 PM

does anyone know if any of these products work on a 3/4 ton? i have a '74 gmc 2500 and all of the parts and kits i've seen say they are for 10's and 15's.

SCOTI · 06-20-2007, 09:18 PM

Quote:

Originally Posted by randyjohn

does anyone know if any of these products work on a 3/4 ton? i have a '74 gmc 2500 and all of the parts and kits i've seen say they are for 10's and 15's.

Measure the diameter of your axle tubes. If they're 3" & the leaf spring width is 2.5", the commom flip kit should work.

randyjohn · 06-21-2007, 04:43 AM

how about the front end? are the a-arms and all that the same from 1/2 to 3/4 ton to allow for the same drop spindles?

longnlow84 · 06-23-2007, 11:20 AM

nice rides guys

randyjohn · 06-24-2007, 03:17 AM

another question: if i use a flip kit, hangers and shackles, or c-notches will i have to lose my aux. gas tank?

bigblock73 · 06-24-2007, 09:57 AM

I am not even sure you can do a flip, shackles and hangers without seriously modifying your frame, bed floor, and wheel tubs. It will all fit (depending on tire size), but your suspension travel will be limited with mods. It also depends on where this auxilary fuel tank is located.

06-12-2007, 08:43 PM	#51
knightlife Dark Heart Motorsports Join Date: Apr 2007 Location: 29404 DKFX Posts: 683	Re: Flip kit? + Shackles? How low can I go in the back. I use the "Toxic Shox" that I found on stylin concepts...they work pretty smooth __________________ How Deep Can YOU Bleed..? 1985 Chevy Blazer K5- 6.2 N/A, 400 turbo trans CUCV, 12v converted... a new chapter 2005 GMC Sierra Crew Cab 6.0 powwwaa!!! custom jumpseat install w/ captain seats, Hypertech tuner, MSD Blaster Coils, CB and twin antenna's, all electric interior, touch screen in dash. custom center console, with jump seat replacing original console. 1500 HD!

06-13-2007, 11:22 AM	#53
Mr79C10 It Is What It Is,,,, Join Date: Aug 2006 Location: The Gun Shine StateFlorida* Posts: 1,765	Re: Flip kit? + Shackles? How low can I go in the back. Can a leaf be added to "stiffin" up a bit? __________________ 79 C10 Short Box ST8 6 bang'r Lowered w/ 3" Control arms, 2" Lower Coils and 4" shackles and hangers W/ FLIP KIT __--__* 79 C-10 project* .........................__ ..............._____ l __\___ ..............\|_(O)_ \|___(O) ] FAQ INDEX Thread The Kulture My Rat Den

06-20-2007, 09:14 PM	#54
randyjohn Registered User Join Date: Jun 2007 Location: grand forks, nd Posts: 154	Re: Flip kit? + Shackles? How low can I go in the back. does anyone know if any of these products work on a 3/4 ton? i have a '74 gmc 2500 and all of the parts and kits i've seen say they are for 10's and 15's.

06-21-2007, 04:43 AM	#56
randyjohn Registered User Join Date: Jun 2007 Location: grand forks, nd Posts: 154	Re: Flip kit? + Shackles? How low can I go in the back. how about the front end? are the a-arms and all that the same from 1/2 to 3/4 ton to allow for the same drop spindles?

06-23-2007, 11:20 AM	#57
longnlow84 Registered User Join Date: Jun 2007 Location: phoenix Posts: 19	Re: Flip kit? + Shackles? How low can I go in the back. nice rides guys

06-24-2007, 03:17 AM	#58
randyjohn Registered User Join Date: Jun 2007 Location: grand forks, nd Posts: 154	Re: Flip kit? + Shackles? How low can I go in the back. another question: if i use a flip kit, hangers and shackles, or c-notches will i have to lose my aux. gas tank?

06-24-2007, 09:57 AM	#59
bigblock73 yeller Join Date: Oct 2001 Location: Twin Cities Posts: 13,824	Re: Flip kit? + Shackles? How low can I go in the back. I am not even sure you can do a flip, shackles and hangers without seriously modifying your frame, bed floor, and wheel tubs. It will all fit (depending on tire size), but your suspension travel will be limited with mods. It also depends on where this auxilary fuel tank is located. __________________ Jeff 73-87.com 73-87.com Facebook page 73-87 cab corner 6x9 speaker brackets for sale 67-72 cab corner speaker brackets for sale 47-54 cab corner speaker brackets for sale



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.