Quote:
Originally Posted by Andy4639
Ace in the hole,
Can you give out some info on your tach? What brand is it and where did you find it?
I have a couple of old dashes I need to redo.
|
I got mine at summit. It's a VDO vision series here's a link-
http://store.summitracing.com/partde...5&autoview=sku
Installed very easily, I took a hole saw and cut the plastic lens out, cut the front tin plate and the back tin plate. Then assembled it all and cut the printed circuit board where I needed to. The gauge mounts so simple right to the front bezel with a plastic screw on ring. As for wiring it, you need power, ground and the signal connections along with the dash light connections. I am going to tap off the ground screw for all the grounds, off the temperature gauge feed screw for power (need to figure out which side) and run a lead from my hei dist. for the signal. You can also use a signal from a alternator lead. The lights I will just tap into the wire for the dash lights on the harness. You end up cutting one line of the circuit board but it's just the ground line. I cleared the plastic off and re grounded the one side with the screw you see in the pic