Engine Wire Loom Routing

[bigsnookmaster]

I also run a Painless harness. I ran the engine bay wires back into the cab, over the top of the trans tunnel, down the pass side of the floor, then drilled a hole and ran them through the floor, and tucked and routed them inside the framerail. I had to lengthen several of them. Hiding the wires for the clean look is a PITA, and seems to take about 3 times as long, but I think it's worth it. I also hid all my MSD wires, and run the plug wires under the headers.The guages on top of the motor were temporary, and the aluminum box with the Bowtie is something I made to hide the outside of the fuseblock. Here's a few pics: