|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-01-2004, 09:21 PM
|
#1 |
|
Insert witty comment here
Join Date: Nov 2003
Location: Lakeville Minnesota
Posts: 388
|
Taking off Harmonic balancer
It seems to be on there real good. I'm using a Harmonic balancer puller but it seems to not want to come off. I don't think I'm suppose to wack it with a hammer. Any suggestions?
__________________
So many trucks, So little time! |
|
|
|
11-02-2004, 01:56 AM
|
#2 |
|
Registered User
Join Date: Jan 2004
Location: Belleville NJ/Dingmans Ferry Pa
Posts: 24
|
Harmonic balancer
No It is not a good idea to whack it with a hammer.Did you take the bolt out of the center. When you put the harmonic balance puller tighten the bolts good then you need to turn the center of the puller and the balancer will start to come off very slowly. You do not want to grab the balancer by the outside to pull it off because there is a rubber ring in the center and you will just pull the outer ring off. If you have any questions let me know. Good luck.
Tom 
__________________
1982 Chevy C20 4wd 1965 Impala wagon (4wd) 1965 Biscayne Wagon (Stock) 1965 ImpalaSS Ragtop 1969 Camaro) 1974 GMC 7500 Dump Truck !992 Chrysler Lebaron Ragtop !993 Ford Mustang GT Ragtop |
|
|
|
|
11-02-2004, 07:43 PM
|
#3 |
|
Account Suspended
Join Date: Apr 2004
Location: N.C. high country
Posts: 6,107
|
make sure the big washer is off too. I have had that problem a few times.
|
|
|
|
|
11-03-2004, 03:38 PM
|
#4 |
|
Registered User
Join Date: Jan 2004
Location: Garland TX Dallas area
Posts: 658
|
I had a cheap puller that the bolt was locking up on It was made of a soft metal. I went and rented one from A-Zone that was a gold color and it came right off.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
