3/4 to 1/2 ton rear-end yoke?? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

67Blacksheep · 04-08-2002, 08:12 PM

Gentlemen-
When the Eaton rear end comes out, and the new 1/2 ton 67 rear end goes in, will I need a different yoke at the rear end? Or will the u-joint and all bolt right in?? I hope the drive shaft is the same length...I just thought of that. Crap.

------------------
67 Chevy C20 LB Stepside,
350 4-bolt with goodies.

67Blacksheep · 04-08-2002, 10:03 PM

Anyone?

69 longhorn · 04-08-2002, 10:38 PM

You can get a conversion joint(2 different sized caps & widths). You might try a local driveline shop.....69

04-08-2002, 08:12 PM	#1
67Blacksheep Registered User Join Date: Mar 2002 Location: Ohio Posts: 135	3/4 to 1/2 ton rear-end yoke?? Gentlemen- When the Eaton rear end comes out, and the new 1/2 ton 67 rear end goes in, will I need a different yoke at the rear end? Or will the u-joint and all bolt right in?? I hope the drive shaft is the same length...I just thought of that. Crap. ------------------ 67 Chevy C20 LB Stepside, 350 4-bolt with goodies. __________________ '94 GMC Seirra Ext. Cab '67 Formula Firebird '89 GSX-R 750

04-08-2002, 10:03 PM	#2
67Blacksheep Registered User Join Date: Mar 2002 Location: Ohio Posts: 135	Anyone? __________________ '94 GMC Seirra Ext. Cab '67 Formula Firebird '89 GSX-R 750

04-08-2002, 10:38 PM	#3
69 longhorn Registered User Join Date: Aug 2001 Location: rock island,il,usa Posts: 5,382	You can get a conversion joint(2 different sized caps & widths). You might try a local driveline shop.....69 __________________ http://community.webshots.com/user/hotrodhorn



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.