Throttle Cable question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Russell · 11-08-2004, 07:02 PM

Ok, as some of you may know, I am swaping to TPI, which requires that I put a longer throttle cable on so it'll reach the throttle body. Anyways, I bought a stock Camaro cable, but it's connection to the firewall is quite a bit different than the stock one. Is there some way that a guy can remove those two little "nuts" at the end of the cable to slide the cable out, cut off the camaro's firewall connector, then drill out the stock one and cement it to the new cable?

Jonboy · 11-09-2004, 10:20 AM

would it be easier to split the throttle cable grommet with a dremel or something similar? If not, I hear the lokar cable is the way to go.

11-08-2004, 07:02 PM	#1
Russell Professional Grade Join Date: May 2003 Location: Fort McMurray, Alberta Posts: 7,915	Throttle Cable question Ok, as some of you may know, I am swaping to TPI, which requires that I put a longer throttle cable on so it'll reach the throttle body. Anyways, I bought a stock Camaro cable, but it's connection to the firewall is quite a bit different than the stock one. Is there some way that a guy can remove those two little "nuts" at the end of the cable to slide the cable out, cut off the camaro's firewall connector, then drill out the stock one and cement it to the new cable? __________________ 1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap)

11-09-2004, 10:20 AM	#2
Jonboy Slots go on anything! Join Date: May 2003 Location: Richardson, TX Posts: 5,957	would it be easier to split the throttle cable grommet with a dremel or something similar? If not, I hear the lokar cable is the way to go. __________________ 1974 Jimmy- 5.3/4L80e/NP241



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.