F/S 4 speed/rockwell tc - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jose · 05-14-2005, 04:46 PM

I converted my 68 GMC SWB 4x4 to automatic so i don't need manual trans anymore . F/S 4 speed tranny , rockwell transfer case , driveline rear only for SWB , clutch pressure plate , fly wheel , high hump cover , rubber floor mat . Tranny and tc works perfect 175.00 and no shipping located in Salem , Oregon . Jose

jose · 05-16-2005, 11:55 PM

Still have it how about 150.00 and no shipping . Jose

stllookn · 05-17-2005, 12:43 AM

Jose, My son is building a 4x4 out of my '72 Longhorn. I will ask him if he needs it. I am assuming that it is all in excellent operational condition?

jose · 05-17-2005, 01:16 AM

stllookn Tranny and TC are in excelent working condition .

*bisquik65* · 05-17-2005, 08:29 AM

I would buy that if you were closer

Shipping that heavy thing would cost... I have that setup in my 70 blazer now.
Bump for ya!!!

charlieo · 05-17-2005, 10:51 PM

I surly could use that sheet metal to NM !!

Hoods69BadBowTie · 05-19-2005, 02:35 PM

Exactly what kind of tranny is that? Looks like my sm465 in my truck?
Thanks, maybe interested if I get some funds.
-Later

jose · 05-19-2005, 03:11 PM

bisquik65 shipping would be expensive .

Sorry charlieo sheet metal goes with the tranny set-up .

Hoods69BadBowTie Tranny is an sm420 . The sm420 is 2 inches shorter than the sm465 .

BobS · 05-19-2005, 04:25 PM

The tranny looks like an SM-465, SM-420s only have one PTO port and it's on the drivers side. Last year for the SM-420 was 67.

Bob

toroflow · 05-26-2005, 03:48 PM

would buy if you would ship to so Cal.

Rod · 05-27-2005, 12:14 AM

That 420 tranny made it into a few produced GMC's up here in Canada a little later than 67....I had one in my 69 GMC 3/4 ton 4x4 that I had once.

boraxman · 05-27-2005, 01:24 AM

Dont wanna hijack

ive got a 420 w/PTO that had been rebuit at some point and worked fine when pulled. Sell cheap.

jose · 05-27-2005, 02:11 AM

toroflow that thing weighs a ton well almost . I will consider shipping if i dont sell it localy .

I am almost positive it is a sm420 . I measured a sm465 out of a 71 and it measured 2 inches longer .

Rod · 05-27-2005, 08:31 AM

Run the tranny through the gears while it's sitting there...reverse is which way? Then you'll know.

05-14-2005, 04:46 PM	#1
jose Registered User Join Date: Feb 2001 Location: Salem , Oregon 97301 Posts: 1,796	F/S 4 speed/rockwell tc I converted my 68 GMC SWB 4x4 to automatic so i don't need manual trans anymore . F/S 4 speed tranny , rockwell transfer case , driveline rear only for SWB , clutch pressure plate , fly wheel , high hump cover , rubber floor mat . Tranny and tc works perfect 175.00 and no shipping located in Salem , Oregon . Jose Attached Images __________________ 68 GMC 4x4 SWB jose6772@yahoo.com

05-16-2005, 11:55 PM	#2
jose Registered User Join Date: Feb 2001 Location: Salem , Oregon 97301 Posts: 1,796	Still have it how about 150.00 and no shipping . Jose __________________ 68 GMC 4x4 SWB jose6772@yahoo.com

05-17-2005, 12:43 AM	#3
stllookn Saving 1 truck at a time! Join Date: Aug 2001 Location: Kent, WA Posts: 6,465	Jose, My son is building a 4x4 out of my '72 Longhorn. I will ask him if he needs it. I am assuming that it is all in excellent operational condition? __________________ '68 C20 Longhorn 50th Anniversary 400/TH400 '68 C20 Longhorn 50th Anniversary 468/TH400w/buckets '72 C20 Halfhorn (Longhorn w/o cab and front clip) '69 Flxible Cruiser (look up ugly in the dictionary)

05-17-2005, 01:16 AM	#4
jose Registered User Join Date: Feb 2001 Location: Salem , Oregon 97301 Posts: 1,796	stllookn Tranny and TC are in excelent working condition . __________________ 68 GMC 4x4 SWB jose6772@yahoo.com

05-17-2005, 10:51 PM	#6
charlieo Registered User Join Date: Feb 2003 Location: sw Posts: 341	High hump sheet metal I surly could use that sheet metal to NM !!

05-17-2005, 08:29 AM	#5
bisquik65 Account Suspended Join Date: Apr 2004 Location: N.C. high country Posts: 6,107	I would buy that if you were closer Shipping that heavy thing would cost... I have that setup in my 70 blazer now. Bump for ya!!!

05-19-2005, 02:35 PM	#7
Hoods69BadBowTie Chevys Kick A$$ Join Date: Jan 2005 Location: Zootown, MT Posts: 12,699	Exactly what kind of tranny is that? Looks like my sm465 in my truck? Thanks, maybe interested if I get some funds. -Later __________________ HOODS is what I answer too -'79, '77, '88 Pickup Sold, '85 Camaro, '83 T/A, '81,'83,'90 K5 Blazer All Sold -'79 3/4 ton "Big Yellow Bananna" Lifted 4spd. 39.5 TSL Swampers, The money Pit -'86 K5 Blazer Silverado 6.2 4" lift 35"s -'95 Ext. Cab Shorty 4" Tuff Country rolling 35" M/T's -'83 Monte Carlo T-Tops. 126,500 Original Miles -LATER I would rather push a Chevy then drive a ford!!

05-19-2005, 03:11 PM	#8
jose Registered User Join Date: Feb 2001 Location: Salem , Oregon 97301 Posts: 1,796	bisquik65 shipping would be expensive . Sorry charlieo sheet metal goes with the tranny set-up . Hoods69BadBowTie Tranny is an sm420 . The sm420 is 2 inches shorter than the sm465 . __________________ 68 GMC 4x4 SWB jose6772@yahoo.com

05-19-2005, 04:25 PM	#9
BobS Senior Member Join Date: May 2001 Location: West Central Minnesota Posts: 569	The tranny looks like an SM-465, SM-420s only have one PTO port and it's on the drivers side. Last year for the SM-420 was 67. Bob __________________ V-6....only GMC Trucks have it! 62 GMC W5000 NAPCO-V6 65 GMC 2500 NAPCO Panel-V6 66 GMC 1000-V6 66 GMC 1500-V6 67 GMC K1500-SBC (originally a KM-V6) 68 GMC C1500-V6 68 GMC C1500-V6 68 GMC Suburban C2500 70 Chevy K20-SBC 71 Chevy C30 Longhorn-SBC 72 GMC Suburban C1500-BBC 72 Chevy C10-SBC 72 GMC C5500-ToroFlow Diesel

05-26-2005, 03:48 PM	#10
toroflow Registered User Join Date: May 2005 Location: Anaheim, CA Posts: 103	would buy if you would ship to so Cal.

05-27-2005, 12:14 AM	#11
Rod Join Date: Dec 1999 Location: Eastern - Manitoba Canada, Winnipeg Posts: 4,369	That 420 tranny made it into a few produced GMC's up here in Canada a little later than 67....I had one in my 69 GMC 3/4 ton 4x4 that I had once. __________________ Senior active founding member. 70 3/4 ton GMC Suburban 4x4 250/4 spd. 71 1/2 ton Suburban Chevy 4x4, 350/350 72 Chev 1 ton tow truck 402BB w/Holmes 440 wrecker on propane 2005 FLSTSCI Harley Springer 85 FXSB Harley Lowrider 72 Triumph 650 Bonneville 5spd "Poor people don't have hobbies" Quote from wife.

05-27-2005, 01:24 AM	#12
boraxman Keepin an eye out Join Date: Feb 2003 Location: So.Cal Posts: 3,920	Dont wanna hijack ive got a 420 w/PTO that had been rebuit at some point and worked fine when pulled. Sell cheap. __________________ 1970 Chevy C10 SWB 5.3 1996 Toyota Tacoma SR5 4x4 2007 Vespa GTS 250 Scooter ZIP 91351

05-27-2005, 02:11 AM	#13
jose Registered User Join Date: Feb 2001 Location: Salem , Oregon 97301 Posts: 1,796	toroflow that thing weighs a ton well almost . I will consider shipping if i dont sell it localy . I am almost positive it is a sm420 . I measured a sm465 out of a 71 and it measured 2 inches longer . __________________ 68 GMC 4x4 SWB jose6772@yahoo.com

05-27-2005, 08:31 AM	#14
Rod Join Date: Dec 1999 Location: Eastern - Manitoba Canada, Winnipeg Posts: 4,369	Run the tranny through the gears while it's sitting there...reverse is which way? Then you'll know.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.