|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-24-2002, 07:42 PM
|
#1 |
|
Registered User
Join Date: Mar 2001
Location: Medicine Hat, Alberta, Canada
Posts: 1,508
|
Early 60's front end swap?
What is the scoop for putting a coil/disc front end into a early 60's torsion bar truck? Is it basically a bolt in, or is it a big hassle? I can't decide if I should just put in a whole front clip or not. I will be adding bags.
|
|
|
|
08-14-2002, 12:41 AM
|
#2 |
|
Registered User
Join Date: Jan 2001
Location: Fairfield, IL
Posts: 42
|
Hey, Z16. I have a 62 that I removed the torsion bar setup and replaced it with a crossmember and suspension from a 72. It was basically a bolt in, I think I may have had to drill 1 or 2 holes on both frame rails for bolts. I welded it to the frame for good measure, but I don't think it was necessary. I have since heard from others that crossmembers and suspensions from 1/2 ton trucks up to 87 will fit as well with minor modification since they are all basically the same width.
Toddro
__________________
'70 Chevy C10 longbed: bone-stock! '72 Lincoln Mark IV: yeah, I know it's a Ford, but it's cool! Soon to be smoothed and bagged... |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
