|
04-08-2006, 04:57 PM
|
#1 |
|
Registered User
Join Date: Mar 2004
Location: Portland, Oregon
Posts: 232
|
2nd Gen. RX7 R&P...
Hey guys,
I just scored a 2nd Gen. RX7 power rack and pinion and was wondering if it would work on my 64? I didn't know what it was off of til I got it home. It was brand new and didn't cost me anything so I figured either way it was worth finding out if it would work. Is it going to be too small or do you guys think I can get it to work? Thanks Keith |
|
|
|
04-12-2006, 01:00 AM
|
#2 |
|
Chevy truck addict
Join Date: Apr 2005
Location: Thornton Colorado
Posts: 825
|
Re: 2nd Gen. RX7 R&P...
TTT 4 ya man
|
|
|
|
|
04-12-2006, 05:07 PM
|
#3 |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: 2nd Gen. RX7 R&P...
Reguardless of whatever else it may take to make it physically fit in the truck, the most important factor is the length of the main unit (where the inner tie-rods connect) The pivot point of the inner tie-rods must be the same width as the distance between the ball-joint holes on the center link (the rod between the steering arm and the idler arm). If they are not the same you will have bump-steer problems (odd handling)
|
|
|
|
|
04-12-2006, 11:07 PM
|
#4 |
|
Registered User
Join Date: Mar 2004
Location: Portland, Oregon
Posts: 232
|
Re: 2nd Gen. RX7 R&P...
Thanks LongHair!
I havent measured yet cause I have decided it is not going to be strong enough, but I know it is VERY close just by looking so I will check it out just for the hell of it. Keith |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
