The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Suspension

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 07-19-2006, 06:37 PM   #1
nwmod39
Registered User
 
nwmod39's Avatar
 
Join Date: Sep 2005
Location: spokane, washington
Posts: 302
crossmember removal

i am getting ready to remove the front crossmember from my 80 c-10 and would like to know if i should take a few measurement first. there is a couple of the holes that look like you can shift the member back/forward so should i?
or could i just remove the member and bolt it back up with no worries.
i am not going to be doing any mods to the member, i just want it out so when i coat the member i get all the way around everything.

thanks
steve
__________________
1980 c-10: under destruction

http://photobucket.com/albums/c372/nwmod39/
nwmod39 is offline   Reply With Quote
Old 07-19-2006, 08:30 PM   #2
Shane
Account Suspended
 
Shane's Avatar
 
Join Date: Jun 2000
Location: over yonder
Posts: 14,270
Re: crossmember removal

not sure it can be reassemble more than one way, but if you are concerned about it you could always mark 1 hole on from each frame rail with a center punch
Shane is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:17 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com