|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-15-2007, 12:00 AM
|
#1 |
|
Registered User
Join Date: Jul 2006
Location: Calgary, Canada
Posts: 43
|
Cigarette lighter removal?
Stupid question for the group - before I tear into it with a big screwdriver...
How does one go about gracefully removing the cigarette lighter in these trucks? Without prying on things I can't see what is holding it in. Thanks |
|
|
|
05-15-2007, 12:01 AM
|
#2 |
|
Registered User
Join Date: Jan 2007
Location: Puyallup, WA
Posts: 1,662
|
Re: Cigarette lighter removal?
Good question, I was wondering the same thing? Soooo....
__________________
72 C10 lwb fleetside -stock 350/350 combo |
|
|
|
|
05-15-2007, 12:12 AM
|
#3 |
|
Registered User
Join Date: Apr 2005
Location: BC, Canada
Posts: 122
|
Re: Cigarette lighter removal?
On all the cigarette lighter removals I've done there's usually an outer casing on the back. This outer casing essentially sandwiches the cigarette lighter housing to the dash. Sometimes they're rusted on pretty good but most times I've been able to get them off by hand. Long story short: reach behind the dash and unscrew this outer casing. The rest should fall out of the dash.
PS: make sure you unplug the power wire. Better yet, before you do that make sure you disconnect the battery, unless you want a shower of sparks 
|
|
|
|
|
05-15-2007, 12:13 AM
|
#4 |
|
Registered User
Join Date: Apr 2006
Location: MinneSNOWta
Posts: 1,381
|
Re: Cigarette lighter removal?
reach up behind, disconnect the wires, and grab the housing and un screw it.
i usually stick my thumb in the hole to hold the inner piece while i unscrew it. 
__________________
2003 GMC Sierra 1500 WT 1995 Nissan Hardbody 2016 Hyundai Veloster Turbo DC2 (SW/AW) Clyde W. Harvey USN "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery" Winston Churchill |
|
|
|
|
05-15-2007, 12:13 AM
|
#5 |
|
Registered User
Join Date: Jan 2007
Location: Bellingham, washington
Posts: 260
|
Re: Cigarette lighter removal?
Under the dash, behind the lighter, there is a sleeve that acts like a nut. Very thin tin-like nut about an inch long. Unscrew it from the back and pull the lighter out from the front. The beizel around the lighter will come off after you pull the lighter.
__________________
68 4x4, 454, 4 speed, disk brakes both ends, Sold my 69 SS396 Elcamino when young & stupid 
|
|
|
|
|
05-15-2007, 12:24 AM
|
#6 |
|
Registered User
Join Date: Jul 2006
Location: Calgary, Canada
Posts: 43
|
Re: Cigarette lighter removal?
That was simple once someone points out that was 2 pieces I was looking at.
Thanks all |
|
|
|
|
05-15-2007, 10:52 AM
|
#7 |
|
Senior Member
Join Date: Aug 2005
Location: OKC, OK
Posts: 2,364
|
Re: Cigarette lighter removal?
I guess I will be ripping mine out because I have tried to unscrew it and it just spins without giving up
Mike
__________________
Mike Redpath |
|
|
|
|
05-15-2007, 10:59 AM
|
#8 | |
|
Registered User
Join Date: Apr 2006
Location: MinneSNOWta
Posts: 1,381
|
Re: Cigarette lighter removal?
Quote:
I've found in that situation, if you use channel locks to compress it a little bit (mutch like crimping a wire), you can engage the threads enough to unscrew it... good luck
__________________
2003 GMC Sierra 1500 WT 1995 Nissan Hardbody 2016 Hyundai Veloster Turbo DC2 (SW/AW) Clyde W. Harvey USN "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery" Winston Churchill |
|
|
|
|
|
05-15-2007, 03:15 PM
|
#9 | |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: Cigarette lighter removal?
Quote:
|
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
