Pics inside/ Early Classic Stainless Hoses - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Dub J · 09-08-2007, 09:52 PM

Just installed my new Early Classic stainless steel brake hoses and was wondering if anyone had to grind their calipers like this to make their brake hoses run properly?

Frizzle Fry · 09-08-2007, 11:52 PM

I had to grind a little on mine when I replaced the calipers with a reman pair. I'm not sure where the compatibility issue came from because the discs were installed by a previous owner. I even tried swapping the lines side-to-side, but as you probably found out too that does not work... Grinding the calipers did the trick.

09-08-2007, 09:52 PM	#1
Dub J Junior Member Join Date: Mar 2006 Location: Nashville Posts: 80	Pics inside/ Early Classic Stainless Hoses Just installed my new Early Classic stainless steel brake hoses and was wondering if anyone had to grind their calipers like this to make their brake hoses run properly?

09-08-2007, 11:52 PM	#2
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	Re: Pics inside/ Early Classic Stainless Hoses I had to grind a little on mine when I replaced the calipers with a reman pair. I'm not sure where the compatibility issue came from because the discs were installed by a previous owner. I even tried swapping the lines side-to-side, but as you probably found out too that does not work... Grinding the calipers did the trick. Last edited by Frizzle Fry; 09-08-2007 at 11:54 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.