|
09-30-2007, 06:33 PM
|
#1 |
|
Registered User
Join Date: Aug 2007
Location: Bakersfield, Ca
Posts: 538
|
removing A arms
I'm swapping lower A arms from one truck to another. One set has a lower basket for the spring (gives a 2 inch lower ride.
I've got it all apart and last thing was to remove the bolt on the ball joint(?) Did so but it won't fall out. Did the customary pounding to no avail... is there a spreader tool of some sort to push the bolt/ball joint down and free the A arm? |
|
|
|
10-01-2007, 12:45 PM
|
#2 |
|
Registered User
Join Date: May 2007
Location: Haubstadt, IN
Posts: 8
|
Re: removing A arms
Yeah, called a pickle fork. But you should be able to knock the joint loose by hitting the side of the knuckle with a large hammer; preferably a ball peen. Just hit the knuckle right at the ball joint hole and it should drop right out.
|
|
|
|
|
10-01-2007, 06:17 PM
|
#3 |
|
Registered User
Join Date: Aug 2007
Location: Bakersfield, Ca
Posts: 538
|
Re: removing A arms
Thanks! Not a lot of room to swing though..
Last edited by Mondo; 10-01-2007 at 06:18 PM. |
|
|
|
|
10-01-2007, 06:22 PM
|
#4 | |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,066
|
Re: removing A arms
Quote:
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
