Saturday's Project: Transmission - The 1947 - Present Chevrolet & GMC Truck Message Board Network

*Piston* · 01-04-2003, 05:53 PM

It was built by a place in Topeka but just about any driveline company can do this. The only thing is im using a Long tail transmission so it cuts down on the overall length of the shaft.
Its 65" center to center with a long tail. With this setup I need to trim the crossmember just a hair. With a short tail trans I'm sure you'll need to install a loop in the crossmember because the shaft will hang much lower.
It cost roughly 200.00 w/ujoints and yokes.

01-04-2003, 05:53 PM	#4
Piston Account Suspended Join Date: Oct 2002 Location: Olathe, KS Posts: 2,300	It was built by a place in Topeka but just about any driveline company can do this. The only thing is im using a Long tail transmission so it cuts down on the overall length of the shaft. Its 65" center to center with a long tail. With this setup I need to trim the crossmember just a hair. With a short tail trans I'm sure you'll need to install a loop in the crossmember because the shaft will hang much lower. It cost roughly 200.00 w/ujoints and yokes.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.